| :: Cameleon Pogona :: |
|
Cameleon Pogona Buggy Standard Specifications
Made from 100% stainless steel, the Pogona is one of the most durable buggys ever.
It has been used and approved for racing on the very bumpy beaches in France, and
has since been adopted by most pilots who need to be 100% confident in their buggy.
Forks
The forks are made from a bent 27mm diameter tube for strength. The foot pegs are
welded onto the forks. Laser cut plates are used for the steering parts and the fittings for the front wheel.
Headstock
As the headstock is a part of the buggy which has to withstand significant strain,
we chose a no compromise solution by using a 60x40mm square tube to counter the torque.
The junction between the fork and the headstock is done through two bearings, and a 20mm bolt.
Side Rails
The side rails have been developed to give you one of the most comfortable buggys,
and to keep you from being ejected sideways when flying overpowered.
Rear Axle
The rear axle is 150cm wide, to give you enough grip and stability on any surface.
|
|
|
|
| :: Cameleon Iguana :: |
|
Cameleon Iguana Standard Specifications
If you are a race pilot, then this buggy should be your choice. On the Iguana,
you can trim everything you need to make it yours, and get the best out of it.
One question still remains. Will you be good enough to make the most of it...
Forks
The forks are made from a bent 27mm diameter tube for strength. The foot pegs
are adjustable plates for comfort and the best ergonomics possible. The laser
cut plates are designed so that you can use standard wheels or disk wheels with the same fork.
Headstock
As the headstock is a part of the buggy which has to withstand significant strain,
we chose no compromise with using a 60x40mm square tube to counter the torque. The
junction between the fork and the headstock is done through two bearings, and a 20mm bolt.
Side Rails
The side rails have been developed to give you one of the most comfortable buggy,
and to keep you from being ejected sideways when flying overpowered.
Back Support
To improve the comfort, we chose to add a back support. This helps you keep
the best position for long runs and racing. When buggying through big bumps,
push on the foot pegs and on the back support, and you will see how much power you can hold.
Rear Axle
The rear axle is 155cm wide.
Wheel Camber & Toe Adjuster
Combined with an extra wide axle, cambered wheels will give you extra grip for upwind
reaches. The toe adjuster is used to trim your toe in/ toe out very precisely. With our
new patented system for camber, you can be sure that your camber will be perfectly symmetrical
, and you can change from cambered wheels to straight wheels in one minute.
|
|
|
|
| |
